[MPlayer-users] Any ideas on converting to dv format?
ivan.kowalenko at gmail.com
Sun Jun 25 21:57:32 CEST 2006
-----BEGIN PGP SIGNED MESSAGE-----
On Jun 25, 2006, at 14.58, bonnie clyde wrote:
> Hi all!
> Basically I'm looking to convert with mplayer/mencoder some older
> movies that were converted to avi and mpeg back to dv format that
> matches the output of kino, so's I can do a little cutting.
Kino can't do format importing? Most other tools I've worked with
can. You should check it out, it could save you a lot of time,
effort, and disk space.
> Below is one of kino's output files, with "mplayer -identify" run
> on it. How would I match them up so the output would be identical
> to this?
Yeah, we got that it was DV. All DV files are the same, where the
only differences exist between PAL and NTSC.
You'll need LibDV installed, and then you'll have to recompile
MPlayer to use it. Just use mencoder and output to livdv, but make
sure you scale up to 740x480 and have the framerate set properly.
I've had problems with libdv before, however, and it's far from
perfect. YMMV. Good luck.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (Darwin)
-----END PGP SIGNATURE-----
More information about the MPlayer-users