[FFmpeg-devel] [PATCH] run level decode function for wma &?wmapro

[Sascha Sommer]

Hi,

On Samstag, 13. Juni 2009, Michael Niedermayer wrote:
> On Fri, Jun 12, 2009 at 11:07:36AM +0200, Sascha Sommer wrote:
> > Hi,
> >
> > On Donnerstag, 11. Juni 2009, Michael Niedermayer wrote:
> > > On Thu, Jun 11, 2009 at 10:17:19PM +0200, Sascha Sommer wrote:
> > > > Hi,
> > > >
> > > > attached patch adds a run level decode function that can be used for
> > > > both wma12 and wmapro.
> > >
> > > could you split it into a patch factorizig the code out and one
> > > changing it ?
> > > so that code moving around is seperate from functional changes ...
> > >
> > > [...]
> >
> > Attached patch tries to simplify the run level decode code.
> > The order of the different cases for the codes is swapped so that the
> > code < 0 check can be dropped (may this happen anyway?).
>
> it depends on the vlc table, if there are no unused sequences of bits,
> that is every sequence of bits will decode as some code then <0 is not
> possible
> (if it is possible that <0 happens then it must be checked for and error
> concealment be performed) but my gut feeling says MS did not leave unused
> codes
>

There are no unused codes. Is this patch and the other patch that changes the 
coefficient buffers to float ok then?

Regards

Sascha