[FFmpeg-devel] [PATCH 07/19] Make the Tips section visible in the man page, and fix texi2pod.pl rendering.

[Stefano Sabatini]

---
 doc/ffmpeg-doc.texi |   20 ++++++++++++++------
 1 files changed, 14 insertions(+), 6 deletions(-)

diff --git a/doc/ffmpeg-doc.texi b/doc/ffmpeg-doc.texi
index 2f8c9db..fb8f17a 100644
--- a/doc/ffmpeg-doc.texi
+++ b/doc/ffmpeg-doc.texi
@@ -740,9 +740,11 @@ FFserver (see the FFserver documentation). When FFmpeg will be a
 video player it will also be used for streaming :-)
 
 @chapter Tips
+ at c man begin TIPS
 
 @itemize
- at item For streaming at very low bitrate application, use a low frame rate
+ at item
+For streaming at very low bitrate application, use a low frame rate
 and a small GOP size. This is especially true for RealVideo where
 the Linux player does not seem to be very fast, so it can miss
 frames. An example is:
@@ -751,31 +753,37 @@ frames. An example is:
 ffmpeg -g 3 -r 3 -t 10 -b 50k -s qcif -f rv10 /tmp/b.rm
 @end example
 
- at item  The parameter 'q' which is displayed while encoding is the current
+ at item
+The parameter 'q' which is displayed while encoding is the current
 quantizer. The value 1 indicates that a very good quality could
 be achieved. The value 31 indicates the worst quality. If q=31 appears
 too often, it means that the encoder cannot compress enough to meet
 your bitrate. You must either increase the bitrate, decrease the
 frame rate or decrease the frame size.
 
- at item If your computer is not fast enough, you can speed up the
+ at item
+If your computer is not fast enough, you can speed up the
 compression at the expense of the compression ratio. You can use
 '-me zero' to speed up motion estimation, and '-intra' to disable
 motion estimation completely (you have only I-frames, which means it
 is about as good as JPEG compression).
 
- at item To have very low audio bitrates, reduce the sampling frequency
+ at item
+To have very low audio bitrates, reduce the sampling frequency
 (down to 22050 Hz for MPEG audio, 22050 or 11025 for AC-3).
 
- at item To have a constant quality (but a variable bitrate), use the option
+ at item
+To have a constant quality (but a variable bitrate), use the option
 '-qscale n' when 'n' is between 1 (excellent quality) and 31 (worst
 quality).
 
- at item When converting video files, you can use the '-sameq' option which
+ at item
+When converting video files, you can use the '-sameq' option which
 uses the same quality factor in the encoder as in the decoder.
 It allows almost lossless encoding.
 
 @end itemize
+ at c man end TIPS
 
 @chapter Examples
 @c man begin EXAMPLES
-- 
1.7.0