[MPlayer-users] Unknown audio format on "Your Highness" BD

[Reimar Döffinger]

On Sat, Aug 18, 2012 at 11:32:17PM +0200, Alexander Roalter wrote:
> On 08/18/2012 09:42 PM, Reimar Döffinger wrote:
> >On Fri, Aug 17, 2012 at 03:06:42AM +0200, Alexander Roalter wrote:
> >>On 08/16/2012 11:40 AM, Carl Eugen Hoyos wrote:
> >>>Alexander Roalter <alex <at> roalter.it> writes:
> >>>
> >>>>After I have solved (somewhat) the problems with current mplayer, I was
> >>>>able to play back the BD with the lavf demuxer, but ran into some major
> >>>>issues with jerky playback, b/c the main feature is built up of single
> >>>>clips (because two cuts of the movie are included), and where the movie
> >>>>branches to different takes, stuttering happens, and seeking is a nightmare.
> >>>
> >>>(Still _every_ necessary information missing.)
> >>>
> >>>Is this reproducible with ffplay?
> >>>If yes, please either open a ticket or at least provide a sample so
> >>>I can open the ticket. Given the rate of patches in FFmpeg, this is
> >>>possible (or even likely) to get fixed.
> >>
> >>It is not reproducible with ffplay, here it plays just fine.
> >>
> >>But I better postpone that to a later time, it's also quite
> >>difficult providing a sample, as the source file is almost 24GB in
> >>size, and the first problems happen a few minutes into the movie.
> >
> >You can cut ts files arbitrarily, if you add a keybinding that prints
> >MPlayer's current stream position you should be able to figure out
> >from which to which bytes to cut out of it.
> 
> I will keep that in mind and try to isolate the parts that have lavf
> demuxer seek improperly...
> 
> Hm... binding the command run "echo ${stream_pos} >> edl" to a key
> produces only empty new lines... Don't know why. If I bind it to
> osd_show_property_text "${stream_pos}", it works though. Will use
> the latter to find the suspicious part.

Did you use an old version from before the patch that implemented that
for run? (in which case the shell would have replaced it, and that
didn't have a stream_pos variable defined).
Because it works for me.