[MPlayer-users] Help w/ compiling source

[Richard Geddes]

OK, the video part works fine, and even though I did have the dvdnav-dev
packages installed, configure did not include it.  I later found some
info in the DOCS section about how to 'properly' compile in support for
dvdnav... 

My question this time is about OSD... I installed the libxosd-dev
package, but ./configure doesn't detect it and I didn't find any DOCS
like that for dvdnav for alternate osd-dev headers. 

What is the requirement to configure OSD into mplayer?

Thanks

Richard Geddes wrote:
> Hi,
>
> I recently followed the mplayer compiling instructions
>
> ./configure
> make
> sudo make install
>
> I wanted to include pulseaudio and jack support.   Figured out I needed
> the dev packages (I'm using Ubuntu 7.10) for jack and PA, and installed
> them.  Configure found the dev files and included the correct options.
>
> The result of my compilation is that I can get audio, but the video is
> not there.  When I run as non-root mplayer outputs a few of these messages
>
> ...
> [radeon] Error occurred during pci scan: Operation not permitted
> [rage128] Error occurred during pci scan: Operation not permitted
> [savage_vid] Error occurred during pci scan: Operation not permitted
> ...
>
> Running mplayer as root I get this output:
>
> ...
> VIDEO:  [XVID]  640x272  12bpp  23.976 fps  659.4 kbps (80.5 kbyte/s)
> Clip info:
>  Software: FairUse Wizard - http://fairusewizard.com
> Can't open /dev/fb0: No such file or directory
> [fbdev2] Can't open /dev/fb0: No such file or directory
> VO: [v4l2] No such file or directory
> vo_cvidix: No vidix driver name provided, probing available ones (-v
> option for details)!
> [radeon] Found chip: Radeon RV250 If [Radeon 9000]
> [radeon] Video memory = 128Mb
> [radeon] Set write-combining type of video memory
> [radeon] DVI port has DFP monitor connected
> [radeon] CRT port has no monitor connected
> [VO_SUB_VIDIX] Description: BES driver for Radeon cards.
> [VO_SUB_VIDIX] Author: Nick Kurshev.
> ...
>
> but there is no video... 
>
> Originally I  installed mplayer from the std Ubuntu package, and
> video/audio was fine.  Normally video would pop up i na separate window.
>
> Thanks for any help....
>
> Info about my video card:
>
> sudo lspci -v
>
> 01:00.0 VGA compatible controller: ATI Technologies Inc Radeon RV250 If
> [Radeon 9000] (rev 01) (prog-if 00 [VGA])
>         Subsystem: ATI Technologies Inc Unknown device 0002
>         Flags: bus master, stepping, fast Back2Back, 66MHz, medium
> devsel, latency 66, IRQ 11
>         Memory at e8000000 (32-bit, prefetchable) [size=128M]
>         I/O ports at 9000 [size=256]
>         Memory at e0100000 (32-bit, non-prefetchable) [size=64K]
>         [virtual] Expansion ROM at e0120000 [disabled] [size=128K]
>         Capabilities: [58] AGP version 2.0
>         Capabilities: [50] Power Management version 2
>
> 01:00.1 Display controller: ATI Technologies Inc Radeon RV250 [Radeon
> 9000] (Secondary) (rev 01)
>         Subsystem: ATI Technologies Inc Unknown device 0003
>         Flags: bus master, stepping, fast Back2Back, 66MHz, medium
> devsel, latency 66
>         Memory at f0000000 (32-bit, prefetchable) [size=128M]
>         Memory at e0110000 (32-bit, non-prefetchable) [size=64K]
>         Capabilities: [50] Power Management version 2
>
> _______________________________________________
> MPlayer-users mailing list
> MPlayer-users at mplayerhq.hu
> http://lists.mplayerhq.hu/mailman/listinfo/mplayer-users
>
>