[MPlayer-G2-dev] mencoder-g2 ?
D Richard Felker III
dalias at aerifal.cx
Thu Aug 7 08:10:05 CEST 2003
On Wed, Aug 06, 2003 at 06:13:51PM -0400, Bobby Bingham wrote:
> On Mon, Aug 04, 2003 at 11:56:18PM +0200, Fabian Franz wrote:
> > In my opinion a cfgfile-format would be nice ...
> > And then gui could create those cfgfile, whic hcan then be run in the
> > background. Of course this cfg-file should be human-readable ...
> > But I think commandline does get so long and file is an nice solution to
> > specify all rules needed for the whole process.
> > cu
> > Fabian
> that's probably best for complex encodes. i'd like to also support a
> command-line similar to the current mencoder that for single audio/video
> stream encodes.
> i don't know mplayer's command-line parsing system very well. is there
> a way to have the video encoder specified with it's params as suboptions
> like "-ovc lavc:codec=mpeg4:hq:pass=1". i think that's better than
> having to add a new option (-lavcopts, -xvidencopts, etc) for every new
> audio/video encoder.
Any suggestions on how you put defaults in your config file with a
system like this?
> i also haven't looked closely at the muxing code from mencoder, but i
> seem to recall it sounding like a pain when the mpeg muxer was added
> (which doesn't always seem to work for me, but that's another story).
> is the current muxer code good/extensible enough? it might also be nice
No, current muxer code is horrible.
> to use the libavformat muxers from ffmpeg, which already does both avi
> and mpeg muxing AFAIK.
No, libavformat is also horrible... :(
More information about the MPlayer-G2-dev