[FFmpeg-user] Capture Video from Decklink Video Render

[Yugant Khanna]

HI Andrew , would dnxhd support 720X576 format ?

On Thu, Dec 13, 2012 at 4:15 AM, Andrew Sinclair <ajsinclair at gmail.com>wrote:

> Did you try DNxHD as the video codec? Which is the native Avid format
>
>
> On 13 December 2012 03:49, Yugant Khanna <yugant at gmail.com> wrote:
>
> > yes ofcourse segment muxer will work. i can set "-f segment -segment_time
> > 10"  and create 10 mins Video clips and then transcoding each the Video
> > clips into MXF or Mov using FFMEG or FMBC?
> >
> >  i did try and do the above way couple of days back but the issue was in
> > the second Output002 file the audio and Video wre not in sync .. i shall
> > try and post the command line in few hours ...
> >
> > or if i don't make any sense please post one command line that i can try
> >
> >
> > regards
> >
> >
> > On Wed, Dec 12, 2012 at 9:05 PM, Roger Pack <rogerdpack2 at gmail.com>
> wrote:
> >
> > > On 12/11/12, Yugant Khanna <yugant at gmail.com> wrote:
> > > > Hi Roger , I need to slice the Video while its getting captured ..
> Till
> > > now
> > > > only mxf is allowing me to do that . I tried the same with .AVI but
> no
> > > luck
> > > > . Can you suggest any other container where i can save and still
> slice
> > my
> > > > Video ?
> > >
> > > Does the segment muxer work for you at all?
> > > -r
> > > _______________________________________________
> > > ffmpeg-user mailing list
> > > ffmpeg-user at ffmpeg.org
> > > http://ffmpeg.org/mailman/listinfo/ffmpeg-user
> > >
> > _______________________________________________
> > ffmpeg-user mailing list
> > ffmpeg-user at ffmpeg.org
> > http://ffmpeg.org/mailman/listinfo/ffmpeg-user
> >
> _______________________________________________
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> http://ffmpeg.org/mailman/listinfo/ffmpeg-user
>