[FFmpeg-user] Capture Video from Decklink Video Render

[Andrew Sinclair]

Did you try DNxHD as the video codec? Which is the native Avid format


On 13 December 2012 03:49, Yugant Khanna <yugant at gmail.com> wrote:

> yes ofcourse segment muxer will work. i can set "-f segment -segment_time
> 10"  and create 10 mins Video clips and then transcoding each the Video
> clips into MXF or Mov using FFMEG or FMBC?
>
>  i did try and do the above way couple of days back but the issue was in
> the second Output002 file the audio and Video wre not in sync .. i shall
> try and post the command line in few hours ...
>
> or if i don't make any sense please post one command line that i can try
>
>
> regards
>
>
> On Wed, Dec 12, 2012 at 9:05 PM, Roger Pack <rogerdpack2 at gmail.com> wrote:
>
> > On 12/11/12, Yugant Khanna <yugant at gmail.com> wrote:
> > > Hi Roger , I need to slice the Video while its getting captured .. Till
> > now
> > > only mxf is allowing me to do that . I tried the same with .AVI but no
> > luck
> > > . Can you suggest any other container where i can save and still slice
> my
> > > Video ?
> >
> > Does the segment muxer work for you at all?
> > -r
> > _______________________________________________
> > ffmpeg-user mailing list
> > ffmpeg-user at ffmpeg.org
> > http://ffmpeg.org/mailman/listinfo/ffmpeg-user
> >
> _______________________________________________
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> http://ffmpeg.org/mailman/listinfo/ffmpeg-user
>