[FFmpeg-user] Capture Video from Decklink Video Render

[Yugant Khanna]

yes ofcourse segment muxer will work. i can set "-f segment -segment_time
10"  and create 10 mins Video clips and then transcoding each the Video
clips into MXF or Mov using FFMEG or FMBC?

 i did try and do the above way couple of days back but the issue was in
the second Output002 file the audio and Video wre not in sync .. i shall
try and post the command line in few hours ...

or if i don't make any sense please post one command line that i can try


regards


On Wed, Dec 12, 2012 at 9:05 PM, Roger Pack <rogerdpack2 at gmail.com> wrote:

> On 12/11/12, Yugant Khanna <yugant at gmail.com> wrote:
> > Hi Roger , I need to slice the Video while its getting captured .. Till
> now
> > only mxf is allowing me to do that . I tried the same with .AVI but no
> luck
> > . Can you suggest any other container where i can save and still slice my
> > Video ?
>
> Does the segment muxer work for you at all?
> -r
> _______________________________________________
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> http://ffmpeg.org/mailman/listinfo/ffmpeg-user
>