[FFmpeg-devel] [PATCH]Remove framerates from dnxhd encoder help

Carl Eugen Hoyos cehoyos at ag.or.at
Mon Aug 31 12:55:01 CEST 2015

Hendrik Leppkes <h.leppkes <at> gmail.com> writes:

> On Fri, Aug 28, 2015 at 11:05 AM, Carl Eugen Hoyos wrote:
> > Attached patch removes the framerate from the output shown
> > by the dnxhd encoder if bad properties were chosen:
> > The framerate is ignored and the table seems very difficult
> > to maintain and is therefore incomplete, see ticket #3342.
> As i understand it, the frame rate is an integral part of the DNxHD
> profile, and even though its not validated and only shown in the
> output, I think this information should be kept.

I just tested with QT:
Both files with 10fps and high bitrate and files with 65fps with low 
bitrate are detected and played back correctly.

So afaict, the patch is correct.

Carl Eugen

More information about the ffmpeg-devel mailing list